Some applications such as blowing chips or debris out of a pipe or blind hole, it may not be possible to blow forward. The pipe may be too long, making it impossible to push the debris all the way down the pipe or the other end of the pipe may not be open. In either of these scenarios, the Back Blow Nozzle is the right tool for the job. An array of holes around the diameter of the Back Blow Nozzles provides a powerful 360° airflow pattern that will clear out any leftover coolant or chips from the machining process.
EXAIR has three different size Back Blow Nozzles; the 1004SS (M4 x .5), the 1006SS (1/4 NPT), and the 1008SS (1” NPT). The 1004SS is recommended for use on pipes as small as ¼” and up to 1”. The 1006SS can be used for a wide range of pipe sizes, from 7/8” up to 4”. The 1008SS nozzle offers the greatest overall force for stubborn or sticky materials stuck to the inside diameter of the pipe. This nozzle is suitable for use in pipes ranging from 2”-16”. As the Back Blow Nozzle will be blowing chips and debris back out of the pipe towards the operator, it is always recommended that a Chip Shield is used. The strong polycarbonate Chip Shield will keep them safe from flying debris and keep you in compliance with OSHA directive 1910.
All of EXAIR’s Back Blow Nozzles are available with extensions. For the 1004SS we have extensions from 6”-36”, and from 12”-72” for the 1006SS and 1008SS. The Back Blow Nozzle can also be installed on our VariBlast, Soft Grip, Heavy Duty, and Super Blast Safety Air Guns. With such a wide range of available sizes and configurations, we can tackle just about any internal pipe cleaning application. If you have a process in your facility that may benefit from the use of one of these nozzles, Please contact us.
<<CLICK HERE>> to visit our website
#22, 1 Floor, 1 Cross, Adj. to IIMB Compound, Bilekahalli Indl. Area,
Bannerghatta Road, Bangalore - 560 076
Ph : 080 - 2648 1309, 4170 1145.
Mob : 097404 39220