Thursday 21 February 2019

Removing machine dust by Exair 120022 2" Aluminium Super Air Amplifier

Company manufactures welded tubing. Shavings are building up at the cutoff operation causing missed locations and tubes cut off to wrong length. Using the Model 1100 Super Air Nozzle to direct the shavings towards the  Model 120022 2"(51mm) Super Air Amplifier, the cut off area was vacuumed clear so the next part could be located properly. This eliminated short pieces.

Super Air Amplifier Performance at 80 PSIG (5.5 BAR)

Monday 18 February 2019

Siphon Fed Atomizing Nozzles Selection

When we recommend an Atomizing Nozzle for a particular application, we try to obtain as much general information as possible about the application, such as:

What type of spray pattern do you need?
How wide of an area needs to be covered?
What kind of flow rate needs to be achieved?
Is the liquid source pressurized?
What is the viscosity of the liquid?
While all of this information is going to help simplify the selection process, when we get a reply that the liquid isn’t pressurized, the choice becomes a little less complicated.

Exair Siphon Fed Atomizing Nozzles are the preferred solution in applications where a pressurized liquid source isn’t available. With a steady supply of compressed air, these nozzles are able to draw the liquid into the nozzle with suction heights up to 36″ for our 1/8″ NPT and 1/4″ NPT nozzles, and up to 24″ for our larger 1/2″ NPT Models. They can also be gravity fed as well.

These nozzles mix the fluid internally and are capable of handling viscosity up to 200 centipoise. Depending on the size of the nozzle and supply air pressure, flow rates can range from 0.4 GPH up to 60 GPH with either a round or flat fan spray pattern. There is also an adjusting valve for more or less liquid flow as needed to fit the demand of the application.


Exair also offers these nozzles with the patented No Drip feature which positively stops the liquid flow when the supply air pressure drops below 30 PSIG, eliminating the need for any additional valves or supply lines.
If you have an application requiring a fine mist of atomized liquid, please contact us in below contact details.
Vivek Engineers#22, 1st Floor, 1st Cross, Adj. to IIMB Compound, Bilekahalli Indl. Area, 
Bannerghatta Road, Bangalore - 560 076.
Ph : 080 -  2648 1309, 4170 1145
Mob : 097404 39220
E- mail : sales@vivekengineers.net , durga@vivekengineers.net