Tuesday 1 December 2020

EXAIR’s Deep Hole Vac-U-Gun

 The Deep Hole Vac-u-Gun is a special iteration of the Vac-u-Gun, designed to provide a solution to the troublesome process of cleaning cavities and drilled holes.

The Deep Hole Vac-u-Gun is a low cost solution to quickly remove chips and debris from grooves and drilled holes where blow gun could create potentially hazardous flying debris. The Deep Hole Vac-u-Gun is simply positioned over the hole, and the trigger squeezed and then a small blow tube delivers a a stream of air to dislodge and lift the chips while the large suction tube vacuum them away. The operator is protected form flying debris since all chips and debris is contained within the clear suction tube. The device is capable of cleaning holes up to 1-1/4″ (32mm) diameter and 18″ (457mm) deep!
How does the Deep Hole Vac-u-Gun work?

Compressed air, normally 80-100 PSIG (5.5 – 6.9 bar), flows through the inlet (1) into an annular plenum chamber (2) when the trigger is pressed. A small amount of air is injected into the blow tube (3) to provide agitation and lift to the chips or debris. The larger airflow is injected into the the throat of the gun through directed nozzles (4). The jets of air create the vacuum at the intake (5) which draws the material in and accelerates it through the unit. The chips, debris or other particulates can then be exhausted into a filter bag or hose attached to the Deep Hole Vac-u-Gun System.

We have found many applications where the Deep Hole Vac-u-Gun is beneficial- including removing chips and debris in:

Holes in fixtures, drilled plastics, T-slot groove cleaning , coolant evacuation from parts, woodworking, tapped holes, cavity evacuation, and many more!

There are many advantages to the Deep Hole Vac-u-Gun, and some are:

Low cost, no moving parts/maintenance free, durable die cast construction, eliminates shock hazard – no electricity, meets OSHA pressure requirements, safe operation – no flying chips, lightweight and portable, and quiet.

The Deep Hole Vac-u-Gun uses less compressed air than ordinary blow guns, and the amplified output flow is 12 times the air consumption rate.


Note that the Deep Hole Vac-u-Gun should not be operated without a filter bag or vacuum hose attached to the exhaust.

There are three (3) Deep Hole Vac-u-Gun System options-


The Model 6094 is the Deep Hole Vac-u-Gun only.

The Model 6194 comes with a reusable bag and clamp for debris collection.

The Model 6394 comes with the reusable bag and a 10′ (3m) section of vacuum hose for transferring the debris to a collection point.

If you have questions about the Deep Hole Vac-u-Gun or any of the 16 different EXAIR Intelligent Compressed Air® Product lines, feel free to contact us.

Vivek Engineers
#22, 1st Floor, 1st Cross, Adj. to IIMB Compound, Bilekahalli Indl. Area, 
Bannerghatta Road, Bangalore - 560 076 
Ph : 080 -  2648 1309, 4170 1145.
Mob : 097404 39220






    


No comments:

Post a Comment