Thursday 14 April 2016

Cooling with an Adjustable Spot Cooler

A window manufacturer contacted to Exair about a cooling application. The company made double pane windows, and the process was assembling two panes of glass separated by a seal that is glued in place.  The adhesive is very similar to hot melt glue.  It is sticky and very hot.  The heat from the adhesive was causing the seals, which were precut to the length of the window, to become flexible and stretchy.  As the laborers were laying the seal, they would have extra material, which would have to be cut.  The excessive heat also made it difficult for the seal to lay flat between the windows.  This would cause a visual defect as well as additional labor time for each window.  They were looking at a way to cool the glue enough to allow the laborers to assemble the window as soon as it came out of the adhesive machine without any issues.
The adhesive was laid in a groove with a raised section just above the surface of the window frame. This was to ensure contact with the seal.  The parts were moving roughly 1 foot/second (30cm/second).  When the product came out, the adhesive was at 260 deg. F (127 deg. C).  For this type of cooling application, I suggested the Adjustable Spot Cooler, model 3825.
Adjustable Spot Cooler
Adjustable Spot Cooler

The reason for the Adjustable Spot Cooler was because of the need for change in cooling capacity. Cooling is relative, and it depends on the difference in temperature as well as flow rate.  So, if the ambient temperature is cool as during the winter time or very hot during the summer times, the cooling rate will need to change.  The Adjustable Spot Cooler has the ability to change the cooling temperature with a turn of a knob.  With the addition of two generators that come with this kit, generators provide control of the incoming air volume and can be switched out to provide more or less cooling capacity. It also has a magnetic base to make mounting easy by placing the unit on the adhesive machine at the required location.
The window manufacturer was able to adapt the Adjustable Spot Cooler to his application and solved both of their issues. Productivity increased and the defects decreased.  Another problem solved by EXAIR products.  If you run into issues with productivity or defects in your application, you can discuss them with one of our Application Engineers.
Vivek Engineers,
#22, 1st. Floor, 1st. Cross,
Adj. IIMB Compound, Bilekahalli Industrial Area,
Bannerghatta Road, Bangalore - 560 076.
Ph : 080 -  3297 0358, 4170 1145
TeleFax : 080- 2648 1309.
E- mail : sales@vivekengineers.net
URL : www.vivekengineers.net
CONTACT PERSONS :
Mr. Durga Madhab Praharaj - Sales & Opearations Manager.
Mob : 097404 39220. E -mail : durga@vivekengineers.net

No comments:

Post a Comment